dust collector strike is a good dust removal equipment, the performance is mainly in the production rate, the small dust collector strike can basically achieve a good rate in the use process, the effect is basically much better than the artificial dust removal, in this process, the dust is definitely no secondary adsorption. Basically avoid the related pollution brought about later. In order to prevent fog during this process and perform the bagging site well, the small dust collector strike makes good use of the blowback effect in the relevant high temperature smoke during this process. Of course, such a tracking system can still grasp such flue gas conditions, and more in this product has a good filtration effect. All machines will have small failures during use, so our small dust collector strike is no exception, but when you encounter a failure, do not worry, to find the problem in a short time and solve it, so that you can stabilize the normal operation of the machine.

Note the following after the dust collector strike installation:

The dust collector strike voltage is three phase alternating current 380 volts, from the dust collector strike external wire connected to the power supply can start to use, the initial rotation, should pay attention to whether the fan is turning (such as reverse, the air volume is very small, need to change the power cable).

2, dust collector strike according to the actual needs, regularly clean the dust, dust collector in the dust cleaning, just when the fan and the cleaning mechanism stop working, open the sealed ash door, draw out the drawer can be.

According to the nature of the dust and the size of the capacity, the dust collector strike should be periodically cleaned, generally three to four times per shift to ensure the normal work of the dust collector.

In order to determine the best working condition of the dust removal equipment, it should be as close as possible to the source of dust, generally 1.5 meters to 2.0 meters, the connection pipe as short as possible, and minimize the elbow, so as not to increase the resistance loss.

5, dust collector strike electric control box cover, can not be opened at will during work, if you need to adjust the cleaning time, or need to check the circuit, should be shut down and cut off the power in the work.

Six, dust collector strike unit is to determine the dust collector strike unit in a better state of the key accessories, the use of units should be based on the appearance of the workpiece size dust properties, in accordance with the principle of pass, close, smooth, seal, design dust cover, the production of ideal dust cover.

7, dust collector strike before work should check the access door, ash door, and air pipe connection system is sealed, so as to avoid leakage, reduce the dust effect.

dust collector strike https://www.kaisenfilter.com/KSDC-8604B-B1-Centralized-Dust-Collector.html