fully automated cnc machines maintenance is good or bad, directly affect the workpiece processing quality and production efficiency. This lathe requires to avoid direct sunlight and other thermal radiation, to avoid too wet, dusty or corrosive gas places. Should not be stored for a long time, it is best to power 1-2 times a week, each time empty run for about 1 hour, in order to use the heat of the machine itself to reduce the humidity in the machine, so that the electronic components will not be damp, but also to find out whether the battery alarm occurs in time to prevent the loss of system software and parameters. The spot check of fully automated cnc machines is the basis of condition monitoring and fault diagnosis, which mainly includes the following contents:

① Fixed point. First of all, we must determine how many maintenance points a tilted bed CNC machine tool has, scientifically analyze the equipment, and identify the possible fault parts. As long as these maintenance points are "watched", the fault will be found in time.

② Calibration. The maintenance point of the boat to formulate standards one by one, such as clearance, temperature, pressure, flow, tightness, etc., must have a clear quantitative standard, as long as it does not exceed the specified standard is not a fault.

③ Regularly. How long to check once, to determine the inspection cycle, to determine according to the specific situation.

④ Define terms. It should also be clear which items are checked at each maintenance point.

⑤ Determine the person. Who carries out the inspection, whether it is the operator, maintenance personnel or technical personnel, should be implemented according to the inspection site and technical accuracy requirements.

⑥ Determine the law. How to check should also have provisions, is manual observation or instrument measurement, is the use of ordinary instruments or precision instruments.

⑦ Check. The inspection environment and steps should be specified, whether it is checked during production operation or shut down inspection, whether it is disintegrated inspection or not disintegrated inspection.

⑧ Record. The inspection should be recorded in detail and filled in clearly according to the prescribed format. It is necessary to fill in the inspection data and the difference between them and the prescribed standards, the judgment impression, and the processing opinions, and the inspector should sign and indicate the inspection time.

⑨ Process. Check the intermediate processing and adjustment of v should be processed and adjusted in time, and the processing results are recorded in the processing record. If there is no ability or conditions to deal with it, it shall report to the relevant personnel in a timely manner and arrange to deal with it. But anyone, any time processing must fill in the processing record.

⑩ Analysis. Both inspection records and processing records are periodically analyzed to identify weak "maintenance points." That is, the points with high failure rate or the links with large losses are put forward and handed over to designers to improve the design.

fully automated cnc machines https://www.zjshuangzheng.com/Automatic-CNC-Machine-ES36.html