Are you tired of dealing with water leaks and mold growth in your shower? Installing a plastic shower seal strip can be the solution you've been looking for. Here's a step-by-step guide on how to properly install it.

First, make sure the area where you'll be installing the seal strip is clean and dry. Remove any old sealant or adhesive residue using a scraper or sandpaper.

Next, measure the length of your shower door or enclosure where the strip will go. Use a hacksaw to cut the plastic strip to fit perfectly along that length.

Before applying any adhesive, test fit the strip to ensure it lines up correctly and fits snugly against both surfaces. This will help prevent water from seeping through gaps.

Once you're satisfied with the fit, apply an appropriate adhesive to one side of the strip and press it firmly onto one surface. Hold it in place for a few minutes until it adheres securely.

Repeat this process for each section of your shower door or enclosure that requires sealing. Be careful not to stretch or bend the plastic too much during installation, as this could affect its effectiveness.

Give the adhesive enough time to cure before exposing your newly installed seal strips to water. Follow any specific instructions provided by the manufacturer regarding drying times.

By following these steps, you can ensure that your plastic shower seal strips are installed correctly and effectively protect against water leaks in your bathroom.

https://www.beysent.com/the-essential-guide-to-plastic-shower-seal-strips.html

Plastic Shower Seal Strip https://www.beysent.com/Glass-Shower-Door-Seal-DS03.html